Energy UNITS FOR LIFT TABLE 1
General Description
This power unit is made solely for your small lift table,Consisting of substantial strain gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This power unit has become broadly used inside the field of logistic products such as minifork lift, scissors lift and ariel doing work platforms. The lower-ing movement is managed from the solenoid valve together with the pace controlled by the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
General Description
This electrical power unit is developed exclusively for the medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing motion is 
actived by the solenoid valve as well as the velocity controlled from the adjustable needle valve. When the lift rises to a large positoin, but the power supply is cut, the decreasing movement is controlled from the manual override perform.
Energy UNITS FOR LIFT TABLE three
Standard Description
This power unit is designed solely to the substantial lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve as well as the pace managed by a strain compensated movement manage valve.
Power UNITS FOR LIFT TABLE 4
Common Description
This energy unit is designed solely for the substantial lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived by the solenoid valve as well as the speed managed by the adjustable needle valve. Once the lift rises to a large positoin, but the energy supply is lower, the reducing movement is controlled through the manual override function.
Special Notes
one. This energy unit is of S3 duty cycle, which could only work intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean all of the hydraulic components concerned before set up of the energy unit.
3. Viscosity from the oil shoud be 15~46 cst,which need to also be clean and cost-free of impurities.N46 hydraulic oil is proposed.
4. Oil transforming is needed just after the initial 100 operation hours,afterwards the moment just about every 3000 hours.
5. The power unit proven is designed to be mounted vertically.
