SMR Gearbox Installation
Satisfactory functionality is determined by good set up. lubrication and upkeep. consequently it is necessary the directions while in the set up and upkeep leaflet. supplied with every gearbox. are followed cautiously. several of the vital aspects of belt and torque-arm set up are listed below.
one. Install pulley on gearbox input shaft as close for the reducer doable, and mount reducer on driven shaft as near to bearing as sensible. failure to accomplish this can lead to excess loads from the input shaft bearings and output bearings and could induce their premature failure.
2. Install motor and wedge belt drive with the belt pull at roughly 90° for the center line amongst driven and input shafts. this will likely permit tensioning from the wedge belt drive with all the torque arm which ought to ideally be in tension. if output hub runs anti-clockwise. torque arm really should be positioned the ideal.
3. lnstall torque-arm fulcrum on a rigid support to ensure the torque-arm might be at about suitable angles to your center line with the driven shaft as well as the torque arm situation bolt. make sure there exists adequate consider up from the turnbuckle for belt stress adjustment.
Hold close.
Bell drive could possibly be situated in any effortless postion. should the torque arm is usually to be used to tighten the belts, the drive need to be at about tight angle on the line concerning the input and output shafts.
Bell drive may be found to your appropriate if preferred.
If output hub rotates clock-wise. place belt drive and torque arm in opposite direction to that shown from the illustration.
Torque arm and belt consider up.
Torque arm can be mounted for the appropriate if desired.